The short version of ipamorelin fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-11-24 and is reviewed periodically as new material appears.
Selectivity distinguishes ipamorelin from first-generation secretagogues such as GHRP-6. At doses that reliably raise growth hormone, it shows little stimulation of adrenocorticotropic hormone or cortisol release in animal models, and it does not markedly raise prolactin or appetite. Binding at GHS-R1a on pituitary somatotrophs triggers calcium influx and pulsatile growth hormone secretion. Because the compound mimics the natural ghrelin signal, the release pattern tends to follow the body's own rhythm rather than producing a sustained elevation.
Most published work on ipamorelin comes from rodent studies and small early-phase human trials. Subcutaneous and intravenous routes have been used, while oral delivery is limited by poor absorption and rapid breakdown in the gut. The reported plasma half-life is short, on the order of two hours, and varies with species and assay method. Whether chronic use produces meaningful clinical benefit remains unresolved, and long-term safety data in humans are sparse. No major regulatory agency has approved the compound as a therapeutic drug.
Ipamorelin is a synthetic pentapeptide that belongs to the growth hormone secretagogue family. Its sequence is Aib-His-D-2-Nal-D-Phe-Lys-NH2, incorporating two non-natural residues that resist enzymatic breakdown. Researchers at Novo Nordisk described the compound in the 1990s while searching for agents that release growth hormone with fewer side effects than earlier secretagogues. The molecule acts as an agonist at the ghrelin receptor, also called GHS-R1a, which is expressed in the pituitary and in several peripheral tissues.
Lyophilized material is generally held at minus twenty degrees Celsius or lower, protected from moisture and light. Repeated excursions to room temperature cause condensation inside the vial and gradual moisture uptake, both of which shorten shelf life. Containers should be allowed to equilibrate before opening so that water does not condense on the solid. Dividing a batch into single-use aliquots reduces freeze-thaw cycling. Solid peptide handled this way is usually considered stable for months to years, while the same material in solution degrades on a much shorter timescale.
Common solvents for laboratory work include water, buffered saline, and dimethyl sulfoxide. Once dissolved, the peptide is exposed to hydrolysis and oxidation, and alkaline conditions accelerate breakdown. Low-binding plasticware and the addition of a carrier protein reduce losses to container surfaces, which can otherwise be substantial at low concentrations. Solutions are typically kept cold and used within days. Investigators working with the compound generally prepare fresh working dilutions rather than storing dilute stocks, and they avoid repeated warming of the same vial.
Reversed-phase high-performance liquid chromatography is the standard method for purity assessment, most often on a C18 column with a water and acetonitrile gradient and trifluoroacetic acid or formic acid as an ion-pairing agent. Mass spectrometry by electrospray or matrix-assisted laser desorption confirms the expected mass and reveals truncated or modified sequences. Amino acid analysis and sequencing provide orthogonal structural evidence. Typical impurities include deletion sequences, oxidized products, and dimeric species. Detection wavelength, usually 214 or 220 nanometers, should be reported because response factors differ between peptides.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H49N9O5 | Includes two non-natural residues |
| Molecular weight | About 711.9 g/mol | Confirmed by mass spectrometry |
| Appearance | White to off-white powder | Typical lyophilized form |
| Receptor target | GHS-R1a | Ghrelin receptor agonist |
| Plasma half-life | Roughly 2 hours | Varies by species and assay |
Ipamorelin is a synthetic pentapeptide first described in the 1990s by researchers at Novo Nordisk during a program to develop selective growth hormone secretagogues. Its sequence is Aib-His-D-2-Nal-D-Phe-Lys-NH2, incorporating two non-natural residues, alpha-aminoisobutyric acid and D-2-naphthylalanine. The C-terminus is amidated, and the material is supplied as a white lyophilized powder. The molecular formula is C38H49N9O5 and the monoisotopic mass is approximately 711.85 daltons. The short chain and modified residues give it greater resistance to enzymatic degradation than many larger peptide hormones.
At the molecular level, ipamorelin acts as an agonist at the growth hormone secretagogue receptor type 1a, the same G protein-coupled receptor that binds ghrelin. Receptor activation couples to Gq/11 signaling, raising intracellular calcium through inositol trisphosphate and diacylglycerol, which in turn promotes exocytosis of growth hormone from pituitary somatotroph cells. Ipamorelin binds this receptor with high affinity and shows weak activity at other secretagogue-related targets in vitro. Its action requires the intact receptor and is not reversed by growth hormone-releasing hormone antagonists.
Compared with earlier growth hormone secretagogues such as GHRP-6 and hexarelin, ipamorelin has been reported to produce less stimulation of adrenocorticotropic hormone, cortisol, and prolactin in animal and early human studies. This selectivity is usually attributed to differences in receptor subtype interactions and to the tissue distribution of the receptor. Effects on appetite appear weaker than those of ghrelin itself, although the supporting evidence base is small. Whether these differences produce a distinct clinical profile remains an open question, since controlled human trials are limited.
Research quantities of ipamorelin are typically distributed as a white to off-white lyophilized powder. The solid dissolves readily in water and in aqueous buffers, and stock solutions are commonly prepared in sterile water or a mildly acidic diluent. Adsorption to plastic and glass surfaces can reduce the concentration of very dilute solutions, so containers and transfer steps deserve attention when accurate concentrations matter. Reconstituted material is generally used promptly rather than held for extended periods.
Storage recommendations for the dry solid center on low temperature and low moisture, most often -20 °C in a sealed, desiccated container protected from light. Solutions are less stable than the powder and are usually kept cold and used within a short window. Freeze-thaw cycling is a recognized source of loss, and aliquoting before freezing is a standard precaution. These practices derive from general peptide handling principles rather than from a single published stability trial, so exact shelf lives should be treated as approximate.
Identity and purity assessment for a research peptide of this kind typically combines reversed-phase high-performance liquid chromatography with mass spectrometry. The chromatographic run separates related impurities and yields a purity percentage, while electrospray ionization or matrix-assisted laser desorption mass spectrometry confirms the expected molecular mass. Amino acid analysis or tandem mass spectrometry sequencing can add confidence when material is intended for quantitative work. Laboratories differ in how they calculate and report purity, so figures from different sources are not always directly comparable.
Lyophilized material is generally stored cold and dry, with desiccant, and protected from light. In solution the peptide is more vulnerable: the histidine side chain can oxidize, and repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. A mildly acidic aqueous buffer is often used for short-term handling because it limits several degradation routes. Accurate prediction of long-term stability under a given set of conditions is difficult, and published stability data remain sparse.
== Metal sulfides == Sulfur reacts with many metals. Electropositive metals give polysulfide salts. Copper, zinc and silver are tarnished by sulfur. Although many metal sulfides are known, most are prepared by high temperature reactions of the elements. Sulfide minerals contain the sulfide (S2-) or disulfide (S22-) anions. Typical examples are:
=== Liposomes === Liposomes are structures which consist of at least one lipid bilayer surrounding an aqueous core. This hydrophobic/hydrophilic composition is particularly useful for drug delivery as these carriers can accommodate a number of drugs of varying lipophilicity. Disadvantages associated with using liposomes as drug carriers involve poor control over drug release. Drugs which have high membrane-permeability can readily 'leak' from the carrier, while optimization of in vivo stability can cause drug release by diffusion to be a slow and inefficient process. Much of the current research involving liposomes is focused on improving the delivery of anticancer drugs such as doxorubicin and paclitaxel.
== Publication history == Mogo first appeared in Green Lantern (vol. 2) #188 (May 1985) in a story titled "Mogo Doesn't Socialize" and was created by writer Alan Moore and artist Dave Gibbons. Although initially a one-off character from a short story, the planet has grown in importance in the Green Lantern mythos and is a necessary part of the process for distributing power rings as well as a destination for Corps members to recuperate.
Sources: en.wikipedia.org
== Etymology, usage, and history of -gate == The suffix -gate derives from the Watergate scandal in the United States in the early 1970s, which resulted in the resignation of US President Richard Nixon. The scandal was named after the Watergate complex in Washington, D.C., where the burglary giving rise to the scandal took place; the complex itself was named after the "Water Gate" area where symphony orchestra concerts were staged on the Potomac River between 1935 and 1965. The suffix has become productive as a libfix and is used to embellish a noun or name to suggest the existence of a far-reaching scandal, particularly in politics and government. As a CBC News column noted in 2001, the term may "suggest unethical behavior and a cover-up". The use of “—gate” served well in an era of sound bites politics. Because they were short and memorable, these phrases caught the attention of the public — and because of its origin [Watergate] it carried a stigma around it, making lesser-known scenarios seem more important. Such usage has been criticized by some commentators as clichéd and misleading. James Stanyer comments that "revelations are given the 'gate' suffix to add a thin veil of credibility, following 'Watergate', but most bear no resemblance to the painstaking investigation of that particular piece of presidential corruption". Stanyer links the widespread use of -gate to what the sociologist John Thompson calls "scandal syndrome":
== Nucleotide excision repair == As illustrated above, (+)-benzo[a]pyrene-7,8-dihydrodiol-9,10-epoxide (BPDE) forms bulky covalent DNA adducts with guanines. Most of these adducts can be efficiently eliminated from DNA by the process of nucleotide excision repair. Those adducts that are not removed can cause errors during DNA replication leading to carcinogenic mutations.
gene product Any of the biochemical material resulting from the expression of a gene, most commonly interpreted as the functional mRNA transcript produced by transcription of the gene or the fully constructed protein produced by translation of the transcript, though non-coding RNA molecules such as transfer RNAs may also be considered gene products. A measurement of the quantity of a given gene product that is detectable in a cell or tissue is sometimes used to infer how active the corresponding gene is.
Sources: en.wikipedia.org
The peptide is Aib-His-D-2-Nal-D-Phe-Lys-NH2. Two of its residues are non-natural, which slows enzymatic degradation. The C-terminal amide is common among bioactive peptides.
It binds the same ghrelin receptor but with greater selectivity in functional assays. Preclinical work reports less cortisol and prolactin stimulation at growth-hormone-releasing doses. Those differences are relative, not absolute, and depend on dose and model.
No major regulatory authority has approved it for human therapeutic use. It is sold as a research chemical for laboratory investigation. Clinical status varies by country and is subject to change.
It is reported as the percentage of total peak area in a reversed-phase chromatogram. That number does not reflect water content, residual solvents, or counterions. The actual peptide content is therefore lower than the stated purity figure suggests.